Features: -High efficiency, high reliability -AC input range selected by switch -100%full load burnin test -Protections: Short circuit/Over load -Cooling by free air convection -Fixed switching frequency at 110KHz -1 years warranty -Dimensions: 159*97*38mm(L*W*H)

SPECIFICATIONS

INPUT

Voltage Range	90~135VAC/180~264 VAC47~63Hz
AC Current	1.9A/1151A/ 230 V
Efficiency	78%(SKS-100T-5);   80%(SKS-100T-7.5);  81%(SKS-100T-12);  82%(SKS-100T-15);  84%(SKS-100T-24); 84%(SKS-100T-48);
Inrush Current	Cold start 50A/230V
Leakage Current	<1mA/240VAC

 
OUTPUT

Model	SKS-100T-5	SKS-100T-7.5	SKS-100T-12	SKS-100T-15	SKS-100T-24	SKS-100T-48
DC Voltage	5V	7.5V	12V	15V	24V	48V
Voltage Tolerance	±1.5%	±1.5%	±1%	±1%	±1%	±1%
Rated Current	15A	11A	8.3A	6.6A	4.2A	2.1A
Current Range	0­15A	0­11A	0­8.3A	0­6.6A	0­4.2A	0­2.1A
Rated Power	75W	82.5W	99.6W	99W	100.8W	100.8W
Ripple & Noise	80mVp-p	120 mVp-p	120 mVp-p	120 mVp-p	150 mVp-p	150 mVp-p
DC Adjustment Range	±10%	±10%	±10%	±10%	±10%	±10%
Setup,Rise,Hold Time	300ms,150ms,20ms

PROTECTION

Over Load

115%~150% Protection type: Fold back current limiting, auto-recovery

ENVIRONMENT

Working Temp., Humidity	-10°C~+50°C, 20%~90 %RH
Storage Temp., Humidity	-20°C~+85°C, 10%~95 %RH
Vibration	10~500Hz, 2G 10min./1cycle, period for 60min, each along X, Y, Z axes

SAFETY

Withstand Voltage	I/P-O/P: 1.5KVACI/P-FG: 1.5KVACO/P-FG: 0.5KVAC
Isolation Resistance	I/P-O/P, I/P-FG, O/P-FG: 100M Ohms/500VDC

STANDARD

Safety Standard	Design refer to UL1012, EN60950
EMC Standard	Design refer to EN55022, EN55024, EN61000, IEC801-2,3,4, IEC555-2

OTHERS

Weight	0.51Kg
Packing	30pcs/16.1Kg/1.2CUFT

NOTE

1.All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25°C of ambient temperature.

2.Ripple & noise are measured at 20MHz of bandwidth by using a 12"twisted pair-wire terminated with a 0.1µ &47µ parallel capacitor.

3.Tolerance: includes set up tolerance, line regulation and load regulation

4.The power supply is considered a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.